Concept2 OPK2660, Руководство пользователя

Страница: 67 / 76

INSTALLATION OF THE APPLIANCE
Caution!
Risk of electric shock! Before installation, disconnect the power cord from the wall outlet. Otherwise there is
a risk of death or electric shock.
• Defects caused by improper installation are not covered by the warranty.
• Installation is the responsibility of the customer not the manufacturer.
• The manufacturer bears no responsibility for damage caused to people, animals or property due to incorrect
installation.
• All guards must be placed firmly in their appropriate place in a way they cannot be removed without using
special tools.
• Install the appliance at least 650 mm above the electric and gas cookers or electric and gas hobs.
• Extracted air should not be led to a chimney intended for discharge of flue gases and combustion products
or a shaft serving for ventilation of rooms where fireplaces are situated.
• Any bend of the ventilation pipe should be ≥120°.
• The room must be well ventilated during cooking.
Connection to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the
appliance.
• Only use grounded sockets.
• Do not use multiple sockets, plugs and extension cords.
• The plug of the power cord on the appliance must be freely accessible even after the installation.
• Changes in a connection may only be performed by a qualified professional.
• Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is
connected to the protective conductor of the mains.
• The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad
protective connection.
When installing the appliance, follow these steps:
1. Remove all the packaging and marketing materials before first use.
2. Mark the required installation height 650 mm on the wall behind the cooker or the cooking plate (Fig. 3).
3. Draw a vertical line to mark the centre of the cooking plate (of the cooker).
4. Drill the holes at an appropriate height and attach the hood holder according to Fig. 4 (Step A).
5. Make sure that the bracket is in the horizontal position in order to prevent grease (fat) from being
accumulated on one side after the hood has been hung (Fig. 5).
6. Hang the fume hood on the mounted bracket and attach the lower chimney cover.
7. Mark the points on the wall and drill the holes for mounting the lower chimney part holder as shown in
Fig. 4 (Step B).
8. Attach the flexible exhaust pipe to the exhaust opening. Use a reducer fitting 150/120 mm in diameter, if
required. Insert the second part of the flexible duct in the opening prepared in the wall.
9. Place the lower part as well as the upper part of the chimney on the hood hung (Fig. 7). Lift the upper part
up to the required height and mark holes on the wall for attachment of the upper chimney part bracket.
Subsequently remove the lower as well as the upper chimney part.
10. Drill holes and attach the upper chimney part bracket (step C).
11. Place the lower as well as the upper chimney part. Attach the lower chimney part to the lower chimney
part holder as shown in Fig. 6. Lift the upper part up to the required height and attach the upper chimney
part to the upper chimney part holder as shown in Fig. 7.
12. Plug the power cord into the wall outlet.
67
EN
OPK2660