Concept2 OPK2660, Руководство пользователя

Страница: 66 / 76

Cleaning and replacement of filters
Metal fat filters
When the appliance is in common use, the metal fat filters should be checked or cleaned every month.
In case of more frequent frying or deep frying, shorten this interval.
Do not use the appliance without the metal fat filters properly installed!
1. Remove the metal filter according to Fig. 1.
2. We recommend to soak the metal filters in warm water with a detergent, then to clean with a soft brush,
rinse with clean water and allow to dry. The filters are also dishwasher safe using a program below 60 °C. In
this case, it is necessary to avoid the use of aggressive detergents –the aluminum filters can blacken under
the influence of the chemical reaction.
3. Reinstall dried out filters.
Carbon filter (to be purchased)
This filter is only used for the recirculation mode.
The filter contains an active carbon absorbing the smell being discharged. The active carbon will be saturated
after some time, hence the absorption capacity will be shortened. This filter cannot be washed or cleaned in
any other way.
When the appliance is in common use, the carbon filter should be replaced every 2-3 months. In case of more
frequent frying or deep frying, shorten this interval.
1. Remove the metal filters as shown in Fig. 1.
2. The carbon filters are situated on both sides of the motor. Turn the filters, until they are secured
(see Fig. 2).
3. To replace the carbon filter, proceed in reverse order.
Fig. 1
Fig. 2
Closed
Opened
Opened
Closed
66
EN
OPK2660