Concept2 MNV3660, Руководство пользователя

Страница: 158 / 172

158
EN
MNV3660
Note:
1. 1. In the upper part of the illustration for the installation of the top plate it is shown how many spacer bars and
which screws must be used for installing the spacer bars to the control panel of the dishwasher.
2. The spacer bars are put together; the side without the „pins“ shall be attached to the bottom side of the
dishwasher control panel.
3. The „pins“ on the bottom side of the bars must be removed (cut off). This step must be done otherwise the top
plate would not fit properly.
4. After removing the „pins“, attach the spacer bars with the included screws to the bottom side of the dishwasher
control panel.
5. In the upper part of the illustration for the installation of the top plate it is shown which screws must be used for
the number of spacer bars.
6. After attaching the spacer bars to the bottom side of the dishwasher control panel, the head of the screw must
be at the same level (it must not stick out) as the bottom side of the spacer bar.
Adjusting door spring strength
• The spring strength is preset only for the appliance door itself. After attaching the cover plate the weight of the
door changes.
• You adjust the strength of the springs using the screws located on the bottom part of the front of the dishwasher
(Pic. 15).
• Setting of the springs is correct when the open door stays in the position and does not fall down.
When installing the appliance, follow these steps:
1. Remove all the packaging and marketing materials before first use.
2. Fasten the cover plate to the appliance door. Use the fastening screws and brackets.
3. You adjust the strength of the springs (left and right) using the screws located on the bottom part of the front
of the dishwasher (Pic. 15). To increase the strength turn clockwise. To decrease the strength turn counter
clockwise.
4. Connect the inlet hose to the water supply according to Pic. 17.
5. Connect the drain hose according to Pic. 18.
6. Stick the condensation belt under the kitchen top (step 3). Make sure that the condensation belt is stuck
alongside the edge of the kitchen top.
7. Place the dishwasher into the prepared space.
8. Use the feet at the front and back of the appliance to level it to a horizontal position. Adjust the back feet by
turning the screw on the bottom of the front side of the appliance (step 5). Adjust the front feet by turning
screws located near the feet themselves (step 5B). Use a spirit level Pic. 16).
9. Plug the power cord in the wall outlet.
10. The appliance must be secured after placing and levelling it. Securing the appliance can be done in two ways:
Pic. 15