Concept2 MNV3660, Руководство пользователя

Страница: 152 / 172

152
EN
MNV3660
PUTTING THE APPLIANCE INTO OPERATION
Starting the washing program
1. Open the appliance door.
2. Check the amount of the regenerating salt and refill if needed.
3. One by one pull out the upper and lower rack, load the dishes and then slide the racks back. We recommend
loading the lower rack first and then the upper rack (see „Loading dishware“).
4. Make sure that the water tap is open. Close the door of the appliance.
5. Press button (1) to turn the appliance on.
6. Press button (6) repeatedly to select the desired program. The display (5) shows the preset time of the selected
program. The wash program runs in the following order:
ECO – Glass – 90min – Rapid – Pre-wash – Auto – Intensive – Normal – ECO.
7. By pressing button (4) you can choose whether the upper spray arm, the lower spray arm or both will be
operating for the selected program. This is possible on all washing programs.
8. If you require a delayed start, press the delayed start function button (7) or (9) repeatedly. The delayed start can
be set up to 24 hours.
9. After you select and adjust the desired washing program, press button (10) to start the appliance. The washing
program or the countdown of the delayed start will start.
10. You will hear an eight-fold beep sound after the washing program is done.
11. Press button (1) to turn the appliance off.
12. Hot dishes are very fragile. We recommend leaving the dishes to cool down for about 15 minutes before
unloading.
13. Unload the lower rack first and then the upper rack to prevent the excess water from the upper rack flowing
down on the dishes in the lower rack.
Caution! Be careful while opening the door of the appliance, a large amount of water vapour can be released or
hot water can spurt. There is a danger of scalding!
Note:
Press button (10) to pause the running washing program. While the program is paused, a beep sound occurs once
every minute, until you press button (10) to continue the program or you press button (1) to end the washing
program completely.
Changing the program during the running washing program
If you decide to change the currently running program, make sure there is enough detergent in the dispenser,
or whether it was used and it is needed to be refilled before starting a new washing program (see „Loading the
detergent“).
1. Press button (10) to pause the program.
2. Press and hold button (6) for more than 3 seconds. The appliance will switch to standby mode in which you can
change the washing program setting.
3. Press and hold button (10) after you are done resetting. The washing cycle will continue after a few seconds.
Note:
• If you open the appliance door during the running wash program, the program will be paused. Signal lights go off.
• A beep sound occurs every minute to warn the door is open during the running program.
• The program will continue after a few seconds after you close the door.