75
MNV2560
EN
Fig. 13
Fig. 15
Fig. 14
Fix the holder to the cover plate so that the
holder‘s fixing bolts have sunken heads not
protruding from the cover plate back side.
Mount swivels in holes with a min. diameter of
2 mm (Figure 13) and slide the whole assembly
onto the dishwasher door (Figure 14).
Door lifting spring strength adjustment
The door cover plate weight depends on the
material used. The spring strength can be
adjusted by turning the screws (Figure 15) on
the front side so that the door holds in the
open position, and closes smoothly when
lifted.
Upper hinge
Lower hinge
Cover plate
Outer door cover
Drain hose connection
Connect the drain hose:
a) to the drain tube 40 mm in diameter with a vent,
b) or use the supplied adapter allowing drainage into a sink tub or a bathtub.
Note:
When used, the adapter must be fixed properly. Otherwise, it may come loose and water may spill on the
floor.
c) or use the siphon side hose of the sink or basin. Fix the hose to the lower side of the worktop. Thus, the water is
prevented from flowing back into the dishwasher.
The end of the drain hose should be 400-1000 mm (Figure 16) above the floor, and not immersed in water to
prevent water back flow.
Make sure the hose is not bent or jammed to prevent the water supply from becoming reduced or stopped.
Fig. 16
