71
MNV2560
EN
Note:
When no temperature is indicated for the program phase, the dishwasher does not heat water in that phase.
Note:
For a lightly loaded dishwasher, using the next weaker program is adequate.
Program
Type of soiling
Program stage
Dishwashing detergent
amount
Pre-wash/wash
Washing
time (min)
Energy
consumption
(kWh)
Water
consumption
(l)
For less dirty dishes,
glasses, porcelain
Pre-wash
Wash (40°C)
Rinse (60°C)
Rinse
Drying
20 g
110
0,95
15,8
For dishes for which
rinsing and slight
drying
is enough
Pre-wash (50°C)
Wash (60°C)
Rinse (60°C)
Drying
5/25 g
60
1,1
11
Accelerated program
for less dirty dishes
that do not require
drying
Wash (40°C)
1. Rinse
2. Rinse (45°C)
20 g
35
0,5
11,5
Glass
Program information
The stated data applies under normal conditions.
Major differences may occur due to:
• Differing amounts of dishes,
• The incoming water temperature,
• The water mains pressure,
• The adjacent temperature,
• The voltage tolerance in the mains,
• By deviations in the dishwasher‘s operation (e.g. the temperature, water quantity etc.).
Dishwashing procedure
1.
Open the dishwasher‘s door
2. Check and, if needed, add salt or rinse aid.
3. Pull out, fill, and push in racks in an orderly manner.
4. Put the relevant amount of dishwashing detergent into the corresponding compartments of the container.
5. Close the dishwasher‘s door.
6. Open the water tap fully.
7. Turn on the dishwasher by pressing the main switch (1).
8. Select the required program by repeatedly pressing the P pushbutton (4). The selected program indicator light
goes on.
9. Ending the set of programs is indicated by the sound effect (8 seconds) and the indicator lights up permanent
programs (not flashing).
10. If a delayed dishwashing start is needed, repeatedly press the delayed start function pushbutton (5) in order to
set up the required delay start time (3h/6h/9h/12h). The selected delayed start function turn-on indicator light
goes on.
