OPERATING INSTRUCTIONS
For the first washing, buy
•
regeneration salt (according to the water hardness – see below)
•
dishwasher detergent
•
rinse aid
Use only products designed for dishwashers.
Water softening device
Soft water is needed for effective washing, i.e. water with a low calcium content; otherwise limescale is created on the
dishes and inside the unit. Water from the mains that exceeds the given hardness level shall be softened for use, i.e.
decalcified. This is done by the regenerative salt in the softening device. The settings and necessary volume of the salt
depend on the tap water hardness. Water hardness is marked in equivalent levels, German °dH, French °TH and mmol/l
(milimol per liter – international water hardness unit).
The softener should be set according to the hardness of the local water. You may get the information on the local
water hardness from your local water utilities provider.
To set the water hardness, proceed as follows:
- Open the door and push the (1) button.
- Press the button (5) for 5 seconds
- Press the button (5) to switch between programs H1 - H6.
- These programs detected by a combination of lighted LEDs in the following table.
- Press the button (1) to save and exit setup.
DESCRIPTION OF THE CONTROL PANEL
1. Power On/Off button
2. The wash program selection button
3. Delay button (3,6,9 hours)
4. Half load function button
5. Start / Pause button
6. Diode indicator of On/Off
7. Diode indicator of the chosen wash program
8. Diode indicator of the chosen delayed start
9. Indicators half load and regeneration salt
78
MNV2445
EN
1
6
2
7
8
9
3
4
5