Make sure the power cord is never crimped or damaged by sharp edges. If this occurs,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains when the device is hot in use or before cleaning it.
Only handle the power cord by the plug. Never pull out the plug by tugging the power
cord.
During initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective. It should decrease gradually.
Please don’t project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances. Keep more than 50cm
distance with wall for smooth air flow. Do not obstruct fan to allow maximum
cooling.
If the external flexible cable or cord of bar is damaged it should be replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a
hazard.
4. Operation Instructions
Don’t turn on the fixture if it’s been through sever temperature difference like after
transportation because it might damage the light due to the environment changes.
Make sure to operate the fixture until it is in normal temperature.
Avoid strong shaking during any transportation or movement.
Don’t expose the fixture to overheating, moisture or environments with too much dust
when installing it. And don’t lay any power cables on the floor or it might cause
electronic shock to the people
Make sure the installation place is in good safety condition before installing the
fixture
Make sure to put the safety chain and check whether the screws are screwed properly
when installing the fixture.
