ALARMS
Error 08
“Motor connection failure”
Motor connection is not correct.
- Make sure the motor is connected.
- Check cable and connectors for damage.
Error 09
“Parameters damaged”
Some configuration parameters are incorrect.
- Check the configuration parameters.
Error 10
“Parameters set to factory defaults”
All parameter settings are reset to factory defaults.
- Check all parameter settings.
Error 11
“Loadcell calibration set to factory defaults”
Loadcell calibration is incorrect and is reset to factory defaults.
- Recalibrate the loadcell.
Error 13
“Loadcell connection failure”
-Loadcell connection is not correct.
-Loadcell connector is not connected to the controller.
Error 14
“UDP link error”
No Ethernet connection between the Regrind and Color units
- Check network connections
- Check If IP-address is configured in CONFIGURATION screen
Error 15
“Software version mismatch”
Software versions of the Regrind and Color units are different.
- Check software versions of both units.
7.11 Files
In this “File manager” menu, files (Material curves) can be searched, renamed and deleted.
When entering the file manager menu, it will allow you to search and select from the material (material
calibration) files.
To search the material files:
1.
After confirming, the file list will be shown. Now you can search for files, rename or delete them.
If the Material curve you are searching for is not in the list fill in the first letter(s) or complete name and press
“ENTER”. Now a filtered list appears. (To select a program press “ENTER” and then press
Confirm
)
2.
To go back to the main list fill in with spaces and press “ENTER”.
It is also possible to fill in the Material description immediately in the File Manager and press “ENTER”. To
clear the description, fill in with spaces or select an empty file out of the list.
Search:
= Scroll through the files.
Delete:
= Delete a file, press “ENTER” to confirm.
Rename:
= Rename a file, press “ENTER” to confirm.
7.12 Select mode
In this menu, you can switch from
Regrind
to
Color
modes to:
Do configuration settings
Make loadcell calibrations
Make/Choose material calibrations
Set hopper loader (if selected)
33 Dual Feed TrueFeed Manual
Содержание TrueFeed
Страница 4: ......
Страница 41: ...APPENDIX A TrueFeed Print view INSIDE VIEW OF THE CABINET 37 Dual Feed TrueFeed Manual...
Страница 42: ...APPENDIX B TrueFeed Wiring diagram 38 Dual Feed TrueFeed Manual Only with Dual TrueFeed...
Страница 44: ...APPENDIX D TrueFeed General Dimensions 40 Dual Feed TrueFeed Manual...
