Conair Theralief TN100, Инструкция по эксплуатации, Страница: 8 / 20

STEP 1
CHECK THE BATTERY USED IN THE CONTROL UNIT
The control unit comes with a built-in rechargeable battery, and can be
used directly out of the box. If the LED light on the turned-on control
unit keeps flashing (once per second), it means the battery is running
out. Charge the control unit with the enclosed USB cable. The LED light
flashes (three times per second) during charging, and becomes solid
when the control unit is fully charged.
STEP 2
INSTALL THE CONTROL UNIT ONTO THE ELECTRODE PAD
Snap the control unit onto the white side of the electrode pad.
This should be done before applying the device onto the skin of
treatment areas.
STEP 3
PLACE THE ELECTRODE PAD WITH THE CONTROL UNIT SNAPPED
IN PLACE ONTO THE TREATMENT AREA (SUCH AS YOUR ARM,
YOUR BACK, ETC.)
You can start by applying the pad directly over an area where you
experience pain. However, you may also want to experiment by
moving the pad to adjacent areas. Pain in one area may be caused
by a tight muscle in another area, for instance. After using the
device for a while, you will find what works best for you. Press down
firmly and ensure the pad makes full and firm contact with skin.
NOTE: Make sure your skin is clean, dry, and free of grease or
lotion before putting on the pad.
STEP 4
PRESS THE ON/OFF BUTTON TO TURN THE POWER ON
Press the ON/OFF button to turn on the unit, indicated by a
beep and a steady green LED light. The countdown timer is
30 minutes.
ELECTRODE PAD INSTALLMENT
CONTROL UNIT USB CABLE