![background image](http://html1.mh-extra.com/html/conair/cgs18a/cgs18a_manual_2649685021.webp)
frequency also depends on the hardness of the water used.
To decalcify, fill the water tank with a solution of 1/3 white vinegar
and 2/3 water and replace the water container into its cavity in the
base of the steamer. Place the nozzle head over a sink and switch
the steamer on, to the ‘I’ position. Run the steamer until all of
the liquid has steamed. Turn the steamer off, to the ‘O’ position,
unplug from the power outlet and allow to cool for 30 minutes.
Remove the water container from the steamer and drain the
remaining liquid from the tank and the cavity of the steamer.
Repeat the above procedure as many times as necessary until a
normal steam rate returns, usually 2-3 times. With each repeated
cycle, use a fresh solution of vinegar and water. Run one cycle of
fresh, cold water after the completion of decalcification before
using the steamer again to steam garments and fabrics.
TROUBLE SHOOTING
PROBLEM
POSSIBLE
CAUSE SOLUTION
Steamer fails to
heat
Steamer is not
plugged in
Plug into power outlet and
switch product on
No steam
Water level is low
Switch product off and refill
water container
Water drips from
nozzle
Condensation in hose
Hold the nozzle and hose
vertically and allow water to
drain back into unit
Nozzle gurgles
Condensation in hose
Hold the nozzle and hose
vertically and allow water to
drain back into the unit
Poor steaming
performance
1. Steamer is not
plugged in
2. Decalcification is
necessary
1. Plug into power outlet
2. Follow steps for
decalcification
Note: Minerals in water will vary in different areas. To ensure
continued operation of the steamer, never store without cleaning
and removing excess water from the water container and the
water reservoir.
Содержание CGS18A
Страница 1: ...Model CGS18A PROFESSIONAL GARMENT STEAMER...