CRS-150 1:1 Redundancy Switch
Revision 2
Installation
MN/CRS150.IOM
2–2
3
Inspect the equipment for any possible damage incurred during shipment. Contact the
carrier and Comtech EF Data immediately to submit a damage report if damage is evident.
4
Review the Installation and Operation Manual carefully to become familiar
with operation.
5
Proceed to Section 2.2 Rack-Mounting the CRS-150.
2.2
Rack-Mounting the CRS-150
The CRS-150 is designed to be mounted into the
rear
of a rack,
behind
the CDM-600 modems.
This typical configuration is shown in
Figure 2-1
.
Figure 2-2. Typical CDM-600/CRS-150 1:1 Redundancy Installation
Once the CRS-150 has been installed into operating position, it will be ready for configuration and
cabling connections. Please refer to
Chapter 4. MODEM AND SWITCH CONFIGURATION
and
Chapter 5. CABLES AND CONNECTIONS
for further information.
Содержание CRS-150
