Comtech EF Data CDM-710G, Инструкция по установке и эксплуатации

Страница: 116 / 246

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–40
6.3.2 SELECT: Monitor
Monitor: Alarms Rx_Stats
Event-Log
Alarms are reported under three main categories:
•
Tx path alarms are displayed under the Tx Category
•
Rx path alarms are displayed under the Rx Category
•
Alarms common to the unit are available under the Unit selection
Refer to Table 6-4 for a listing of alarms.
Select Alarms , Rx_Stats , or Event-Log using the ◄ ► arrow keys, then press
ENTER
.
6.3.2.1 (SELECT:) Monitor
Æ
Alarms
Live Alarms: Transmit
Receive Unit ( E)
Select Transmit , Receive , or Unit using the ◄ ► arrow keys, then press
ENTER
.
If Live Alarms: Æ Transmit is selected:
TX Traffic: GBEI Card
PHY Not Connected (E)
This will report only if there are modulator errors; otherwise, it will report “ No Errors .” Press
ENTER
or
CLEAR
to return to the previous menu.
NOTE : The alarm message depicted in the above example usually indicates that the Ethernet data
cable is disconnected from the modem.
If Live Alarms: Æ Receive is selected:
RX Traffic:
Demod Unlocked (E)
This will report only if Demod is unlocked; otherwise, it will report “ No Errors .” Press
ENTER
or
CLEAR
to return to the previous menu.
If Live Alarms:
Æ
Unit is selected:
Unit Fault: No Errors
(E)
This will report only if there are unit faults; otherwise, it will report “ No Errors .” Press
ENTER
or
CLEAR
to return to the previous menu.