7
150 Series
— CompX refrigerator eLock Instructions
a. Screw one tamper resistant sheet metal
screw into the center of the strike's slotted
area.
Note:
The end of the metal strike
needs to curve
out.
b. Place the plastic strike cover over the
metal strike.
c. Attach with one tamper resistant machine
screw.
Secure the strike and attach the strike cover
Step
2:
150 Series
—
Installing the
horizontal
mount refrigerator kit
Mount the CompX eLock
®
housing to the refrigerator door
Step
3:
The CompX eLock can be mounted to the front of the refrigerator by
using the provided foam tape or by drilling holes and using screws
(provided).
Foam Tape Installation
Please note that if foam tape installation is used, the eLock will
not
be adjustable once it is put in place.
a. Clean the front of the refrigerator with rubbing alcohol. Wait for the
alcohol to dry.
b. Click the eLock onto strike plate, ensuring proper latch bolt
engagement and mark the eLock location on the refrigerator door
with a pencil.
c. Remove one side of the protective liner from
the double-sided tape and install on the
CompX refrigerator eLock mounting plate.
d. Attach the mounting plate to the back of the
eLock.
e. Remove remaining protective liner from
double-sided tape.
f. Carefully press eLock onto the refrigerator door in the location as
previously marked.
g. Verify proper operation and alignment.
h. Firmly press eLock onto fridge.
Note:
Temporary support of the
eLock may be required to allow adequate adhesion time of the
foam tape.
Drilling Installation
a. Cut a 3” piece of double-sided foam tape and attach it to the
mounting plate to serve as an location alignment holder.
b. Attach the mounting plate
to the back of the eLock.
c. Click the eLock onto strike
plate, ensuring proper
latch bolt engagement.
Press eLock onto the
refrigerator door.
d. Remove eLock from
mounting plate by
pressing down on the
mounting plate release
tab.
e. Drill eight 9/64” holes through the mounting
plate holes into the refrigerator door. Secure
with mounting plate screws.
f. Attach eLock to mounting plate.
g. Verify proper operation and alignment.
Note:
If foam tape was used to mount the
strike, the eLock refrigerator kit installation
is COMPLETE.
