5
150 Series
— CompX refrigerator eLock Instructions
a. Screw one tamper resistant sheet metal
screw into the center of the strike's slotted
area.
Note:
The end of the metal strike
needs to curve
up.
b. Place the plastic strike cover over the
metal strike. If strike was mounted using
foam tape, please proceed to Step 3.
c. Attach with one tamper resistant machine
screw.
Secure the strike and attach the strike cover (if strike was mounted using foam tape, ONLY do b.)
Step
2:
150 Series
—
Installing the
vertical
mount refrigerator kit continued
The CompX eLock can be mounted to the front of the refrigerator by
using the provided foam tape or by drilling holes and using screws
(provided).
Foam Tape Installation
Please note that if foam tape installation is used, the eLock will
not
be adjustable once it is put in place.
a. Clean the front of the refrigerator with rubbing alcohol. Wait for
the alcohol to dry.
b. Click the eLock onto strike plate, ensuring proper latch bolt
engagement and mark the eLock location on the refrigerator
door with a pencil.
c. Remove one side of the protective liner from the
double-sided tape and install on the CompX
refrigerator eLock mounting plate.
d. Attach the mounting plate to the back of the
eLock.
e. Remove remaining protective liner from double-
sided tape.
f. Carefully press eLock onto the refrigerator door in the location as
previously marked.
g. Verify proper operation and alignment.
h. Firmly press eLock onto fridge.
Note:
Temporary support of
the eLock may be required to allow adequate adhesion time
of the foam tape.
Drilling Installation
a. Cut a 3” piece of double-
sided foam tape and attach
it to the mounting plate
to serve as an location
alignment holder.
b. Attach the mounting plate to
the back of the eLock.
c. Click the eLock onto strike
plate, ensuring proper latch
bolt engagement. Press
eLock onto the refrigerator
door.
d. Remove eLock from mounting plate by
pressing down on the mounting plate release
tab.
e. Drill eight 9/64” holes through the mounting
plate holes into the refrigerator door. Secure
with mounting plate screws.
f. Attach eLock to mounting plate.
g. Verify proper operation and alignment.
Note:
If foam tape was used to mount the strike, the eLock
refrigerator kit installation is COMPLETE.
Mount the main CompX eLock
®
body to the refrigerator door
Step
3:
