Compu Pool E-Series Manual
11
01. Determine the desired position for
the Electronics Module on the wall.
Screw the wall mounting bracket shown
to the wall with the nine screws
provided. If wall plugs are required, use
the bracket as a template to mark the
locations for drilling the holes.
02. Ensure that the four M10 screws are
assembled into the rear of the electronics
enclosure.
03. Check that there is a small gap
(approximately 0.1" / 2mm) between the
screw
head
and
the
enclosure
sheetmetal. This will allow for mounting
onto the bracket keyhole details.
04. With two people, lift the Electronics
Module up. Carefully align the four M10
screw heads with the corresponding
keyhole apertures. Push the screw heads
through the apertures and let them fall into
the slot. The Electronics Module should
now be securely mounted.
