actual weld. When your equipment is built, Component Playgrounds will repair this damage
using a cold galvanizing compound spray along with a top coat of silver aluminum. This is a time
tested and durable process. However, when you are inspecting your playground equipment, if
you notice that some surface rust has appeared on the welds, simply apply a fresh coat of the
cold galvanizing compound and the silver aluminum top coat to keep your structure looking
new. (These spray products can be purchased in shaker cans at most hardware stores and at
Component Playgrounds.)
5.
Plastic Lumber Platforms:
6.
If you have purchased a structure which includes a platform, the
plastic lumber does not need to be finished or stained. It is 100% maintenance free. However,
you may need to occasionally hose it down to remove dirt and other debris that may collect
after many hours of use by happy children.
Vinyl Canopies:
7.
If you have purchased a structure which includes a vinyl canopy, this product
should be inspected occasionally for wear and will need to be replaced as necessary. Depending
upon your environmental conditions, the normal life expectancy of the vinyl canopy is 3 – 5
years.
Swing Seats:
8.
These should be inspected at least twice annually and should be replaced as
necessary.
Slides:
Slides should never be lifted at the bottom. Lifting the slide at the bottom will almost always
cause the slide to crack at the top where it has been attached to the platform or bracket. Cracks
and wear such as is caused by this practice are easily identifiable and will not be covered under
the product warranty.
Slides should be inspected at least annually to ensure that the sliding surface is in
good condition. Also inspect the side rails to be sure that the plastic has not been cut or gouged
in any manner which would present the risk of injury while sliding.
9.
Fasteners:
All fasteners should be periodically inspected to make certain that they are tight
and secure. Re-secure as necessary.
