4
Section 3
Operating Instructions
This section describes how to set up and make measurements with your instrument. We recommend that you
read the entire section carefully so that you can use all the features of your instrument.
Setting up your Tester
Your LCB leakage current measurement instrument is shipped with three cables that connect to detachable
terminal blocks on the input
and output side
on the front of the instrument. One end of each cable is
connected to a detachable terminal block as shown in
Error! Reference source not found.
below. The other
end of each cable is unterminated: these wires should be connected to the EUT and the voltmeter to the output
connector. Note that these cables may be disconnected from the terminal blocks if you choose to use other
test leads.
Figure 1
Test lead wiring
The provided test cables are shielded, and the cable shield is connected to the metal enclosure of the LCB
instrument. The shielded cables may be left unterminated or grounded as needed for testing.
