Comparc S 604 MT, Руководство пользователя

Страница: 10 / 24

PM1326
4-6. SPOOL WIRE INSTALLATION.
FIGURE 4-3 SPOOL WIRE INSTALLATION.
For 8" and 12" (standard) wire spools
turn unit off and disconnect it.
1.- Hub spool.
2.- Pin of Hub spool.
3.- Wire spool / Reel.
4.- Hud spool cap.
Turn the hub spool cap clockwise
and remove it. Install the wire spool, be
sure the hub spool´s pin enters one of the
holes of the wire spool. Reinstall the hub
spool cap.
1
2 3
4
Figure 4-4 Shielded gas connection.
WARNING
SEE SAFETY SIGNALS AT THE BEGINING THIS MANUAL
4-7. SHIELDED GAS CONNECTIONS.
1
2
3
4
5
6
Be sure gas cylinder is held to running gear, wall, or other stationary support
so cylinder can not fall and break off valve.
1.- CAP.
2.- CYLINDER VALVE.
Remove cap, stand to side of valve, and open valve slightly. Gas flow blows
dust and dirt from valve. Close valve.
3.- CYLINDER.
4.- REGULATOR /FLOWMETER.
5.- GAS HOSE CONNECTION.
6.- FLOW ADJUST.
Typical flow rate is 20 cfh ( Cubic Feet per Hour).
28.5, 15.8mm (1-1/8",5/8")
Tools needed:
1.- WIRE SPOOL / REEL
2.- WELDING WIRE.
3.- WELDING WIRE ACCESS.
4.- INLET WIRE GUIDE.
5.- PRESSURE ADJUST KNOB.
6.- DRIVE ROLL.
7.- PRESSURE LEVER.
8.- WIRE JOG BUTTON (SEE FIG. 5-7).
3
WARNING
SEE SAFET Y PR EC AUT IONS AT BEG G ININ G OF M ANUAL
FOR BASIC W ELDING I NFOR M AT ION.
4-8. WELDING WIRE INSTALLATION.
1
4
2
5
6
7
8
WIRE
JOG
5