Comparc S 604 MT, Руководство пользователя

Страница: 13 / 24

PM1326
0
10
20
30
40
60
50
70
80
90
100
FIGURE 5-7 JOG BUTTON
1.- JOG BUTTON
Push and hold button to momentarilly energize feed welding
wire at speed set on wire speed control without energizing
welding circuit of shielding gas valve.
GAS PURGE BUTTON.
Push and hold button to momentarilly energize gas solenoid
and purge air from gun shielding gas regulator without
energizing the welding circuit.
FIGURE 5-8 PURGE BUTTON
Install & Connect
Wire Feeder
Install & Prepare
Gun And Power
Source
Put On Personal
Safety Equipment
Set All
Controls.
Turn On
Shielding Gas
(If Applicable)
Beging
Welding
FIGURE 5-10 GAS METAL ARC WELDING (GMAW) & FLUX CORED ARC WELDING (FCAW).
Turn On
Wire Feeder &
Power Source
FIGURE 5-5 WIRE SPEED CONTROL
1.- WIRE SPEED CONTROL.
Use this control to select wire feed speed in speed ranges.
Turn in clock wise to increase speed. The numbers is a
percentage respect a maximun rated speed (900ipm)
Readjust
Controls If Is
Necessary
1
FIGURE 5-9 TRIGGER MODE SELECTOR.
BURNBACK
Use control to adjust the time that the welding wire is energized after wire
feeding stops.
By adjusting control properly, the welding wire will not freeze in weld puddle
or in contact tip of gun. If welding wire freezes to work, increase burnback
time. If welding wire burns back into contact tip, decrease burnback time.
FIGURE 5-6 BURNBACK CONTROL
BURNBACK
TRIGGER MODE SELECTOR.Use this control to select the desired
trigger mode.
Select always one trigger mode:
1. 2T Trigger mode : When trigger is depressed, weld starts. When
trigger is released, weld stops.
2. 4T Trigger mode : When trigger is depressed, weld starts. When
trigger is released, weld remains. After depressing and releasing
the trigger for the second time, weld stops.
JOG BUTTON
0
1
2
3
4
6
5
7
8
9
10
PURGE
BUTTON
TRIGGER
8