Single-Ended I/O Module
5–18 UltraSCSI RAID Enclosure
7.
On the master enclosure shroud, align the module that has Cable A
(C
ALLOUT
A) attached with the Port 1 backplane connector. Gently
insert the module and fully seat it. Use a screwdriver to tighten the
spring-loaded mounting screws.
8.
On the first expansion I/O
module, align the Cable A
(C
ALLOUT
A) connector
with the left connector.
Gently insert the cable
connector into the module
connector. Tighten both
cable connector thumb
screws to fully seat the
connector.
9.
Install a wire tie through the holes on the cable support bracket and
around the cable. Tighten the wire tie.
10. Using the expansion I/O module in step 8, align the Cable B
(C
ALLOUT
B) connector with the right connector. Gently insert the
cable connector into the module connector. Tighten both cable
connector thumb screws to fully seat the connector.
Table 5–8
Installing Three-Enclosure Subsystem
Cables (Continued)
6
4
2
5
3
1
A
CXO5854B
A
CXO5855B
B