H-12
Compaq ServerNet II PCI Adapter and Switch Installation Guide
Running the Routing Test in Interactive Mode
The interactive mode produces a report similar to the report produced by Batch Mode, as shown
in Figure H-12. Start the CLI by executing the
SODCLI.BAT
program in any standard
Windows 2000 manner.
Enter the following command at the command line:
% ROUTE<TARGET>
Where
TARGET
represents all nodes, or a specifically named node as follows:
ROUTE ALL
Targets all nodes on the SAN that are known to SANman.
Targets a specifically named Source Route, where
TARGET
represents the route, such as:
ROUTE TARGET
ROUTE 0
ROUTE x
ROUTE y 3 5 0
ROUTE 1 3 5 0
Figure H-12. Routing Test Report in Interactive Mode
