B
Hard Drive Installation
Using the Cable-Select Feature with Ultra ATA Devices
Selected models of the Evo Workstation W8000 have an internal
Ultra ATA hard drive installed. The configuration of the drive
employs a cable-select feature that identifies the drive as device 0
(primary drive) or device 1 (secondary drive).
Device 1 is the drive connected to the cable’s middle connector.
Device 0 is the drive connected to the cable’s end connector (applies
only to 80-conductor ATA cables). See “Guidelines for Installing
Ultra ATA Devices” in this appendix for an example of an Ultra
ATA cable.
Compaq hard drives ship with jumpers preset to cable-select mode;
therefore, no jumper setting changes on the existing or optional
drives are required. If you purchase a third-party hard drive, refer to
the documentation included with the kit to ensure proper installation
and configuration of cables.
If you are installing a second device on the primary controller, you
must use an 80-conductor Ultra ATA cable for optimum
performance. This cable is standard on selected models.
Compaq Evo Workstation W8000 Hardware Reference Guide
B
-
1
