Initialization Problem 9
Errors occur in the Gateway-ST initialization process.
Solutions:
There are several possible reasons for this problem:
1.
The Gateway-ST may not be configured. If you configured the Gateway-ST,
the following files appear:
SNAGATEWAY_gateway-node-name_SNA.COM
SNAGATEWAY_gateway-node-name_DNA.COM
If the files do not appear in the directory, run the following utility to
configure the Gateway-ST:
$ SYS$MANAGER:SNACST$CONFIGURE
Refer to DECnet SNA Gateway-ST Installation for information on the
configuration procedure.
2.
When the Gateway-ST was initialized, the SNAINI object did not run.
Following is a list of some of the causes for this problem:
•
The SNAINI object may not be defined. To see if it is defined, issue the
NCP command (for Phase IV):
NCP> SHOW OBJECT SNAINI CHARACTERISTICS
and for Phase V:
NCL> SHOW SESSION CONTROL APPL SNAINI ALL
The display from this command should be the following:
Object Volatile Characteristics as of
dd-mmm-yyyy hh:mm:ss
Object = snaini
Number
= 39
File id
= SYS$COMMON:[SNA$CSV]SNAINI.COM
Proxy access
= incoming
If the SNAINI object is not defined, create it by executing:
$ DEFINE_
gateway-node-name_ON_load-host-node-name.COM
If you cannot find this file, execute Part 1 of SNACST$CONFIGURE.
•
Check the proxy account created during the Gateway-ST configuration.
Invoke the VMS AUTHORIZE utility, and issue the following command:
UAF SHOW SNA$CSV
1–32 Solving DECnet SNA Gateway for Synchronous Transport Problems
