Compaq AP250 - Deskpro Workstation - 128 MB RAM, Руководство по техническому обслуживанию и ремонту

Страница: 138 / 194

System Security 5-7
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: f-ch5 System Security.doc Last Saved On: 10/4/99 4:30 PM
Reenabling Diskette Boot or Diskette Write
The workstation ships with the Diskette Boot or Diskette Write features
enabled. If a user has disabled the factory settings that permit the workstation
to boot from a diskette or to prohibit a user from saving data to a diskette, you
may need to reenable the features to service the workstation. To enable
Diskette Boot or Diskette Write:
1. Turn on the workstation.
2. When the words “F10 = Setup” appear in the lower-right corner of the
screen, press F10.
NOTE: You have approximately two seconds to press F10. If you do not press F10 during
this time, you must turn the workstation off, then on again to access the utility.
3. From the main menu, select Storage, then select Removable Media.
4. Press the up/down arrow keys to select the function you want to enable.
5. Press the left/right arrow keys to select Enable.
6. Save the configuration and exit the utility.
7. Restart the workstation.
IMPORTANT: If you disable the diskette drive, the FailSafe Boot Block ROM will not
perform a system ROM recovery in the event a system ROM failure occurs.
Reenabling a Serial Port or Parallel Port
The workstation ships with the serial and parallel ports enabled. If a user has
disabled either of these ports, you may need to reenable them to service the
workstation. To reenable the ports:
1. Turn on the workstation.
2. When the words “F10 = Setup” appear in the lower-right corner of the
screen, press F10.
NOTE: You have approximately two seconds to press F10. If you do not press F10 during
this time, you must turn the workstation off, then on again to access the utility.
3. From the main menu, select Advanced, then select Onboard Devices.
4. Press the up/down arrow keys to select the Serial or Parallel port you
want to reenable.
5. Press the left/right arrow keys to select the desired port resources.