•
•
•
•
•
Chapter 7
56
•
Make sure the ink cartridges are correctly installed and
snapped into place.
•
Verify the scanner lock (on the left) is in the unlocked
position.
•
Close the front access door.
•
Open the back paper input tray by pressing down on
both latches. Clear any paper jams and close the tray
again.
•
Plug the power cord back in.
WARM UP
This is not an error. The scanner lamp is warming up after a
period of inactivity and will take less than a minute to
complete. Once the scanner is warm, your job will be
performed...no action is required.
UNLOCK SCANNER
When shipping or transporting the A3000, the scanner must
be locked. To use the scanner, however, it must be in the
unlocked position. Turn the power off, unlock the scanner,
and turn the power back on. See “Unlocking and locking
the scanner” on page 45.
SCAN MOTOR ERROR
Most likely the scanner is locked. Follow the procedure
above for the
UNLOCK SCANNER
message.
PRINTER ERROR: ##
You should solve this error in the same manner as the
POWER DOWN ERROR
previously described.
If you are still experiencing difficulty after following those
steps, try removing one cartridge at a time to see if the
message goes away. If it does, try replacing the cartridge
with a new one.
Содержание A3000
Страница 2: ......
Страница 28: ... Chapter 3 24 ...
Страница 42: ... Chapter 5 38 ...
Страница 68: ... Index 64 ...