Compaq 226824-001 - ProLiant - ML750, Руководство по технике безопасности

Страница: 7 / 204

English 1-5
Earth Leakage Current
To reduce the risk of electric shock due to high leakage currents, a reliable
grounded (earthed) connection is essential before connecting power distribution
products to AC power. Observe the following limits when connecting the product to
AC power distribution devices:
!
For UPS products and PDUs that have attached AC power cords or are directly
wired to the building power, the total combined leakage current should not
exceed 5 percent of the rated input current for the device.
!
For UPS products and PDUs that have detachable AC power cords, the total
combined leakage current should not exceed 3.5mA.
Voltage Selection
!
On products that have voltage select switches, make sure that the switch is set
for the type of voltage you use (115 VAC or 230 VAC).
!
Do not attempt to power the product with voltage converter kits sold for
appliances.
Batteries
Some HP products may contain internal lithium manganese dioxide batteries or
vanadium pentoxide batteries. There is risk of fire and burns if the battery pack is
not handled properly. To reduce the risk of personal injury:
! Do not attempt to recharge the battery.
!
Do not expose the battery to temperatures higher than 60°C (140°F).
! Do not disassemble, crush, puncture, short external contacts, or dispose of the
battery in fire or water.
!
Replace the battery only with the HP spare battery designated for this product.
Do not dispose of batteries with the general household waste. To forward them
to recycling or proper disposal, use the public collection system or return
them to HP, your authorized HP Partners, or their agents.
Precautions for Products Installed in Racks
Stability
To reduce the risk of personal injury or damage to the equipment, be sure that:
! The leveling jacks are extended to the floor.
!
The full weight of the rack rests on the leveling jacks.
!
The stabilizing feet are attached to the rack if it is a single-rack installation.
!
The racks are coupled together in multiple-rack installations.
! Only one component is extended at a time. A rack may become unstable if more
than one component is extended for any reason.
! You are careful when pressing the component rail release latches and sliding the
component into the rack. The slide rails could pinch your fingertips.
! You load the rack from the bottom up and load the heaviest item into the rack
first.
! You do not attempt to move equipment racks without adequate assistance, due
to their height and weight.
! You do not attempt to move an equipment rack on an incline that is greater than
10 degrees from horizontal.
! You do not attempt to move a fully loaded equipment rack. Remove equipment
from the rack before moving the rack.
Manual Material Handling
To reduce the risk of personal injury or damage to the equipment:
!
Observe local occupational health and safety requirements and guidelines for
manual materials handling.
! Obtain adequate assistance to lift and stabilize the product during installation or
removal.
! Remove all pluggable power supplies and modules to reduce the weight of the
product.
!
Make sure that the product is properly mated with the rails. Products that are
improperly mated with the rails may be unstable.