9
MACHINE PREPARATION
9. SOLUTION TANK (OPTIONAL)
To insert the solution tank onto the handlebars, proceed as follows:
1.
Secure the handlebars in a position of about 45° to the ground
2.
By loosening the closing knob (1), position the top brackets above half of the column (if these are not
already positioned)
3.
Put the solution tank on the column, so that the bottom of the tank is anchored to the fixed bracket (2)
on the column
4.
While keeping the tank with one hand, move the mobile bracket (3) down until the solution tank is
locked to the column
5.
Lock the position of the mobile bracket (3) by acting on the closing knob (1)
6.
Remove the cap (5) and insert the water distribution tube (4) into the brush solution distribution tube
on the base
7.
hook the solution tank valve tie rod (6) in the handle valve control hook (7)
10. DETERGENT SOLUTION
Fill the solution tank only when the column is in vertical position, by proceeding as follows:
1.
Fill it with clean water at a temperature not exceeding 50
°
C.
2.
Add the liquid detergent to the tank in the concentration and manner indicated on the detergent
manufacturer's label. To prevent an excessive amount of foam that would damage the components
inside the machine, use the minimum percentage amount of detergent recommended by the
manufacturer.
WARNING: you are advised to always wear protective gloves, to avoid the risk
of serious injury to your hands
WARNING: We recommend that you vacuum at intervals the dirt-loaded foam
with a vacuum cleaner for liquids.
4
5
1
2
3
6
7
