14
DAILY MAINTENANCE
PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
15.
DISASSEMBLING THE BRUSHES-PAD HOLDER
1.
Make sure the power supply cable is unplugged from the mains socket
2.
Check that the handlebars are in the rest position
3.
Tilt the machine until bringing the handlebars down to the ground, by putting a foot into the rear of
the base body
WARNING: This operation must be carried out using gloves to protect against
contact with dangerous solutions.
4.
Rotate the brush anticlockwise until it leaves the brush holding tray seat and clean them up with a
jet of water. Check the bristles are not worn; in the event of excessive wear, replace the brushes
(the bristles should be at least 10mm long)
