INS_RL1000GW_REV– 15 Jul 2016 PAGE 19
INSTALLATION AND OPERATION MANUAL
RL1000GW
TECH SUPPORT: 1.888.678.9427
Configuration Environment
A CLI based configuration environment is available for the user.
Command Line Interface
The CLI (Command Line Interface) is used to configure the RL1000GW from a console attached to
the serial port of the router or from a remote terminal using SSH. The following table lists the CLI
environments and modes.
Table 3-1: Command Line Interface
Command
Mode
Access Method
Prompt
Exit Method
Global
Configuration
Environment
(GCE)
Following user log in this mode
is available to the user.
RL1000GW#
To exit this mode would mean the user to log out
from the system.
Use the command ‘exit’
Global
Hierarchy
Configuration
From the Global Configuration
mode command you may drill
down to specific feature sub
tree.
Example is shown here for
router configuration sub tree.
[router/]
To exit one level back, the ‘..’ (Two dots) is used.
Application
Configuration
Environment
(ACE)
The ACE is an alternative
configuration environment for
supported features
ACE#
This mode is not supported at current version
To exit back to the GCE mode use the ‘exit’
command.
ACE Config
Use the command ‘configure’ to
access the ACE Configuration
mode
ACE(config)#
To exit back to the ACE mode use the ‘exit’
command.
Application
Hierarchy
Configuration
Access the target feature. For
example :
‘interface vlan 1’
ACE(config-if-eth1.1)#
To return one level up use ‘exit’.
To return to the ACE use ‘end’.
