ComNav Vector G2, Руководство по установке и эксплуатации

Страница: 31 / 92

ComNav G2 & G2B Installation & Operation
Document PN 29010093 V1.5 - 29 -
16 December 2016
When routing the cable, it is recommended to:
•
Keep the cable well away from rotating machinery;
•
Avoid running the cable in areas of excessive heat;
•
Keep the cable away from corrosive chemicals;
•
Do not run the cable through door or window jams;
•
Do not excessively bend, or crimp, the cable;
•
Avoid running the cables in close proximity to areas known to be of high
electromagnetic emissions;
•
Secure the cable along the route using plastic tie wraps as necessary.
Cables & Extensions
Standard supplied cable length is 15 meters. 30 meters cable Part Number 31110062 is
available if needed, and can be ordered from ComNav. In installations here there seems
to be a significant excess of cable left after routing, the cable can be shortened by cutting
the extra length off the unterminated end.
Cable can be routed into a customized break-out box with internal terminal strips, or use
soldered or crimped, marine-grade and standards, wire-to-wire connection techniques.
If you are using the G2 unit with a Navigator G2 GPS Compass Display, the Navigator
G2’s Distribution Unit contains a terminal strip for extension cable connection.
Cable Colour Codes
Standard Cable ( 15 and 30 meters)
Wire Color
Signal Description
Note
Red Power (+)
Black Power (-)
Brown Port 1 Tx RS232
White/brown Port 1 Rx RS232
Yellow Port 2 Rx RS422 A
White/yellow Port 2 Rx RS422 B
Green Port 2 Tx RS422 A
White/green Port 2 Tx RS422 B
Violet* 1PPS+ / Port 3 Tx RS422 A Shared wires
White/violet* 1PPS- / Port 3 Tx RS422 B
Blue CAN_L
White CAN_H
Pink NET_S
Pink/black NET_C
Orange Alarm 1
White/orange Alarm 2
Gray Port1 GND RS232
Drain
Table 1 - Cable colour code
* Shared wires can only be used for one function. Only available in units with the optional
port.
Power Input
A 3 Amp fast-blow fuse or circuit breaker (not supplied) should be installed in series with
the Power Input wire. An in-line On/Off switch (not supplied) capable of handling 3 Amps
should also be installed. The breaker/fuse/switch and all the power wiring must be