CLOUD 4 and CLOUD 6 – Installation Guide
5
INSTALLATION AND WIRING
Remove the rear cover plate, complete with wire strain relief, by loosening the two screws holding it
in place, and sliding the plate off. Once the cover is removed, open the strain relief fitting by
loosening the horizontal screws.
Run the speaker wires through the strain relief opening. After passing about 4 to 6 inches of wire
through the fitting, tighten the screws on the strain relief to secure the fitting and back plate to the
speaker wire. DO NOT overtighten or you may damage the wire jacket, a snug fit is all that is
required.
Figure 6 – Running wires through opening in strain relief fitting
Tightening onto flexible or hard conduit
– The supplied fitting accommodates up to 3/8 inch
(9.5mm) flexible conduit. Insert the conduit into the strain relief fitting. Using the two horizontal
screws that clamp the fitting together, clamp the conduit securely between them. Be sure to leave at
least 4 to 6 inches of cable beneath the strain relief fitting.
Step 3
Expose the input-terminal on the rear of the speaker
Figure 5 – Removing the
strain-relief fitting
Loosen here
Keyhole
opening
Tighten here
