CLOUD 4 and CLOUD 6 – Installation Guide
8
INSTALLATION AND WIRING
Daisy-chain Wiring (Using Loop-Through Terminals - Pins 1 & 4):
To daisy-chain the wiring, connect the wire pair of the follow-on speaker to pins 1 and 4.
With all wiring to the connector completed, plug the connector into the socket in the speaker’s
terminal cup. Remember to tighten any loose screws to eliminate any vibration. Slip the input
terminal cover back onto the rear of the speaker and tighten the two screws that keep it in place.
Figure 11 – Plug connector
into
connector socket
Step 5
Plug connector into connector socket
_
DAISY CHAIN WIRING
By connecting the wire pair
of the subsequent speaker to
pins 1 & 4, then all
subsequent speakers will be
disconnected when this
speaker’s connector is
disconnected during
troubleshooting. This can
be a useful way to isolate
problems to a section of the
distributed line while
leaving the wires attached
to the connector.
Figure 10 –
Daisy-chain wiring
1
2
3 4
+
+
_
From
amplifier
or
previous
speaker
To next
speaker
