7
4.7 Release the left and right 12W adapters to install the
continuity strap.
Note
: Make sure the PVC tape has no contact with gel
port.
4.8 Check if all cable outer jacket ends contact the port
end-face.
4.9 Close the 12W adapter and secure the 12W cable in
drop port and 26W cable by a tie wrap as shown.
Note: The tie wrap knot is located at the closure
outer surface. (refer to 4.10)
4.10 Tie wrap knot location.
5
Closing of the closure
5.1 Close the closure and check if the screws are in the
right position.
5.2 Close the wedge until a click.
5.3 Tighten the screws at closure two sides to close the
closure.
