Page 4 of 10
© 2019 CommScope, Inc. All Rights Reserved
6.
Product Installation
Notes to consider before installation
Before installing and using FST-T, the user should fully understand the warnings and notes explained in
this
section.
Warning - Danger: Infrared radiation is invisible and can seriously damage the retina of the eye.
Do not look into the ends of the optical connectors or adapters or exposure to laser radiation
may result. Use an optical power meter to verify if an optical signal is present. Do not assume
the laser power is turned off or that the fiber is disconnected at the other end. The dust cap
MUST be immediately placed over any radiating optical connector to avoid the potential of
dangerous amounts of radiation exposure. This practice also prevents dirt particles from
entering the connector.
Do not disassemble the product
The user should not disassemble the product. If the user thinks a repair is necessary, contact the
CommScope Technical Support Team.
Installation site condition
For safe and stable use, the product should be installed in a site satisfying the following conditions:
6.1.
Avoid locations where temperature is too high or low.
6.2.
Keep the product surroundings clean and dust-free both during and after installation.
Satisfying operational environment conditions
FST-T normally operates in an environment with the following conditions:
Operating temperature: -40 - +70ºC
6.3.
Product Dimensions
Figure 6
