8
Installation (continued)
HOMEDEPOT.com
Please contact 1-844-584-3776 for further assistance.
NOTE:
After electrical connections are made, un-hook the hands-free
wire (F) and then mount the fixture onto the mounting plate (D).
E
D
CC
7
Make the electrical
connections
(For wall/eave mount over standard recessed junction box)
8
Secure the fixture and wiring
☐
☐
Once the fixture is wired, place the fixture on the mounting
plate. Use the hex head allen key (CC) to tighten the set
screw (E) to secure the fixture to the mounting plate (D).
Ensure no wires are pinched between the mounting plate
cover (C) and mounting surface.
TIP:
Hold stripped ends near each other
and align any frayed strands (do not twist
wires).
Push the wires into the wire nut (BB) and
use your fingers to twist the wire nut
clockwise until tight. Check for tightness
by pulling wires.
(fig 16).
D
BB
Wall Mount
Swivel Knuckle Flood/
Surface Mount
(fig 17).
BB
☐
☐
☐
If necessary, strip 3/8 in. of
insulation from the junction box and
lighting fixture wires.
Connect wires by twisting the
exposed wires together and using
the wire nuts (BB).
Ensure there are no loose wires.
Connect the lighting fixture black
wire to the junction box black wire
(line), the lighting fixture white wire
to the junction box white wire
(common), and the junction box
ground wire to the green
lighting fixture ground wire.
Black
(Line)
White
(Common)
Green
(Ground)
Junction Box
Non-Dimming Wiring Diagram
(fig 18).
(fig 19).
3/8 in.
