5
2.
Press RESET.
3.
Press TEST (listen for click; Reset button will trip and pop
out).
4.
Press and release RESET (listen for click; Reset button will
latch and remain in). The power supply cord
is ready for
operation.
NOTES:
■
The Reset button must be pushed in for proper operation.
■
The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
■
Do not use the power supply cord as an off/on switch.
■
A damaged power supply cord must be replaced with a new
power supply cord obtained from the product manufacturer
and must not be repaired.
■
The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.
INSTALLATION INSTRUCTIONS
Unpack the Air Conditioner
Remove Packaging Materials
■
Remove and dispose of/recycle packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
■
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
■
Handle the air conditioner gently.
Before Installing Air Conditioner
This air conditioner has been designed for installation through the
wall in a sleeve. It is the responsibility and obligation of the
customer to have this product installed by a qualified technician
familiar with through-the-wall installation.
OR
If you choose to install the air conditioner yourself, read all
installation instructions, as well as the electrical requirements and
operating instructions, before installing your unit. This will help to
avoid any installation problems and will help ensure trouble-free
performance of your new air conditioner.
Install Air Conditioner in Existing Wall Sleeve
■
It is recommended that you remove the existing rear grille and
install the new grille that came with your air conditioner.
■
Handle air conditioner gently.
■
Be sure your air conditioner does not fall out of the opening
during installation or removal.
■
The place where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded outlet.
■
Be sure the wall where the air conditioner will be installed will
support the weight of the unit.
■
Do not install the air conditioner where the plastic cabinet
front will be exposed to a heat source that raises the surface
temperature above 120ºF (49ºC).
■
Do not block the louvers in the front panel.
1.
Measure the existing wall sleeve.
2.
See the section that matches the dimensions of the existing
wall sleeve.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
A. Width (W)
B. Height (H)
C. Depth (D)
D. Horizontal insulation strip
E. Vertical insulation strip
A
B
C
D
E