9
- If the short pin are inserted, switched stand-by mode.
- No CCTV2 signal, transferred (e)
(e) CAM2 (Full)
(f) CCTV2 (Full)
- No CCTV2 signal, switched stand-by mode
- Monitoring sequence during communicating
(a) CAM1 (Full) + CCTV1 (PiP)
- Condition: No CCTV1 signal, Only CA1 (Full) is shown.
(b) CAM2 (Full) + CCTV2 (PiP)
- Condition: No CCTV2 signal, Only CA2 (Full) is shown.
(7) Door release
- The door release works by pressing (door release button) of video phone
during being on the phone.
- The LED of (door release button) is turned on during releasing door.
(In case of being installed door camera with door release function)
(8) Save captured image
This function apply the storage method is "Picture"
If you set auto-save mode, it store image when there is call from camera.
If you press (save image button) or (monitor button) for 1second in
monitoring mode or communicating, 1 cut image will be stored after a recording
icon is displayed in the screen.
(9) Save of video
This function apply the recording method is "video".
It record image when there is a call from camera in auto-recording mode.
If you set auto-save mode, it record video for 30 seconds when there is call from
camera, and for 60 seconds in case of communicating. The maximum time able to
record video for one time is 90 seconds(reply time for call + time for talk)
caution 1
- Don't remove SD card during saving of captured image and video. It may cause
defect or data loss.
caution 2
- The recording image file is only stored in SD CARD. Please note that It is not
available to record image If SD CARD was defective or not put into product.
