APR/16/2002
6979 USA
22
2. Push the Valet switch
10
times and hold it until
five
chirps with a long chirp is hearing then release the
valet switch. You are now in the Start feature
‘II’
programming mode.
Select “Checking Type”:
3. Press the transmitter
button to set the “Timer Checking Type”. [3] LED flash, [3] chirps to confirm this
setting
4. Once you complete step 3, you can adjust and test “Start Timer” as below:
START TIMER PROGRAMMING: (TEST and ADJUST)
While the system stay in Start Feature
“II”
programming mode,
1. Press the
button on the transmitter to start the vehicle.
2. If everything goes well:
a. Press the '
button on the transmitter to stop engine running. You have been completed this
programming successfully.
b. Press
or
button on the transmitter to exit the program mode. There will be 3 long chirps for
confirmation.
3. If the crank time is too long, (Engine already successfully running, while still cranks):
a. Press the
button on the transmitter to stop engine running.
b. Press the
button on the transmitter to set proper “Start Timer”. The chirp & LED pause will confirm
this enter. (Decrease “Start Timer” is necessary.)
c. Repeat the step1 – 4.
4. If the crank time is too short, (Engine not running, while stops cranks):
a. Press the
button on the transmitter to stop engine running.
b. Press
button on the transmitter to set proper “Start Timer”. The chirp & LED pause will confirm this
enter. (Increase “Start Timer ” is necessary.)
c. Repeat the step1 – 4.
RETURN TO FACTORY DEFAULT SETTING:
1. Turn the ignition ON then OFF 3 TIMES and stay in OFF position.
2. Push the Valet switch
12
times and hold it until
six
chirp with a long chirp is hearing then release the valet
switch. You are now in the “Return To Factory Default Setting” programming mode.
3. Press the
+
button on the transmitter together for 6 seconds, there will be a confirmation six
chirp with 3 long chirp to confirm the system “Alarm Feature I & II & III Programming all returns to factory
default setting.
Exit:
Press transmitter’s
button or turn the ignition switch “on” or leave it for 15 seconds. A 3 long chirps
to confirm exit.
SHUTDOWN DIAGNOSTICS
The unit has the ability to report the cause of the last shutdown of the remote start system.
Enter:
1.
Turn the Ignition 'switch to ‘ON position.
2.
Press the
button on the transmitter.
3.
The LED will now report the last system shutdown by flashing for one minute in the following grouped
patterns:
LED
Flashes
Shutdown Mode
1
(-) Safety Shutdown input (Hood)
1. Close the hood.
2. Check H6/1 White/ Black wire connection.
2
(+) Safety Shutdown input (Brake) or
Neutral Safety Switch input fail.
1. Check H6/3 White/ Violet wire connection.
2. Move the Enable Toggle Switch to “ON”
position. (If installed.)
3. Move the gear selector to “Park”/ “NEUTRAL”
position.
4. Check H6/2 Black/White wire connection.
