APR/16/2002
6979 USA
20
7
Temperature-Control
Starting OFF
Temperature-Control
Starting 5 F (
-
15 C)
Temperature-Control
Starting
-
7 F (
-
20
C)
Temperature-Control
Starting
-
22 F (
-
30
C)
Exit
:
Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
START FEATURE “
II
” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
10
times and hold it until
five
chirps with a long chirp is hearing then release the
valet switch. You are now in the Start feature
‘II’
programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Exit the programming mode. (3 long chirp to confirm this exit.)
2
Exit the programming mode. (3 long chirp to confirm this exit.)
3
Tachometer
checking type.
Voltage checking
type
Timer checking type
RPM learning
4
Start Timer:
0.6-second
0.8-second (2 chirps), 1.0-second (3 chirps), 1.2-second (4 chirps),
1.4-second (5 chirps), 1.6-second (6 chirps), 1.8-second (7 chirps),
2.0-second (8 chirps), 3.0-second (9 chirps), 4.0-second (10 chirps),
5
Start the system for TESTING & ADJUSTMENT
6
Hi check level
Low check level
7
Stop the remote start system for TESTING & ADJUSTMENT
Exit
:
Press the
or
button on the transmitter. A 3 long chirps & 3 parking light flashes to confirm exit.
TACHOMETER CHECKING TYPE
Enter Start Feature ‘II’
Programming Mode:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
10
times and hold it until
five
chirps with a long chirp is hearing then release the
valet switch. You are now in the Start feature
‘II’
programming mode.
Select “Checking Type”:
3. Press and release the transmitter
button once to set the “Tachometer Checking Type”. [1] LED flash,
[1] chirp to Confirm this setting.
4. Once you complete step 3, you can program “RPM Learning Mode” as below:
RPM Learning
While the system stay in Start Feature
“II”
programming mode,
1. Press and release the transmitter
button once, [1] chirp to indicate your are in features “RPM
Learning mode”.
2. Start the vehicle with the key. (While the engine is running, the parking & LED will flash, If don’t, please
check tachometer White/Red wire connection. (H6/8)
3. Press and hold the valet switch for 2 seconds until a long chirp and the LED light constant for two seconds.
The RPM signal is learned.
4. Once you complete step 3, turn off the ignition switch to stop the engine then you can adjust and test
“Check Level” as below:
CHECK LEVEL PROGRAMMING: (TEST and ADJUST)
While the system stay in Start Feature
“II”
programming mode,
1. Press the
button on the transmitter to start the vehicle.
2. If everything goes well:
