USER GUIDE • PG5100 PRESSURE GATE • PG5142 TALL PRESSURE GATE
4
21
1
The gate must be installed in a
structurally sound opening. Never install
between two railings or two stair posts.
Ensure mounting surface (wall, doorframe,
etc.) is strong, rigid and is smooth, clean
and grease free. If mounting onto brick,
drywall or other surfaces, an optional gate
installation kit, wooden board mounted to
the surface or additional hardware may be
necessary to provide a solid, smooth
surface. Measure opening to determine if
extensions are needed. Correct width will
be reached by adjusting all 4 corner
spindles. Each spindle adjusts individually
and may be extended to varying lengths
(up to 1 ¾” each) to allow for molding,
uneven walls, etc. This gate can be used
in a closed doorway.
2
Spindle attachment is different
when using optional extensions and
when not using extensions.
Spindle
housings are not used if square extension
tubes are required. If the housings have
been inserted, remove with a screwdriver.
3
Slide top spindles (a) and bottom
spindles (c) into spindle housing end (b).
Push assembly into gate corners.
Installation
1
(a)
(b)
(b)
(a)
(c)
(b)
(b)
(c)
3
2
PAGE LEFT BLANK INTENTIONALLY