Command Communications PrivatePage PS2000AN, Руководство оператора, Страница: 9 / 15

PS2000AN Operator’s Guide
6
Alarm notification paging
The PS2000AN is equipped with two dry contact
closures that when triggered, each contact will page a
single pager or group of pagers automatically.
On the back of the PS2000AN, you will find an RJ-11
four-wire jack that is the contact connection.
The inside two wires are contact number one and the
outside two wires are contact number two.
Installation
To connect one or both contacts, connect a four-wire
RJ-11 telephone cable into the jack connection on the
PS2000AN. Strip the other end of this cable to expose
the red, green, black, and yellow wires.
Contact 1: Connect the red wire to one side on the
contact block. Connect the green wire to the other side
on the contact block. Contact 2: Connect the black wire to one side on the
contact block. Connect the yellow wire to the other
side on the contact block.
Connect to
PS2000AN
jack
When either contact is momentarily closed and then opened (in the case of a doorbell trigger), the PS2000AN will
automatically page the pre-assigned pager.
Storing the pager assignment:
Contact 1 memory position:
1.
Turn the PS2000AN power
ON
.
2. Press the CANCEL button to clear the display.
3. Press the PROGRAM button (the display will
flash) then press the 1 button. The display will
momentarily show what is stored in the memory
position, then
_ _ _ _ will appear in the display.
4. Enter the three-digit pager assignment number and
the digit to be displayed. Example: 3526.
5. After the four-digit code has been entered into the
memory position, the PS2000AN will display
_ _ _ _ again to show that the new entry has been
stored.
Contact 2 memory position:
1.
Press the
CANCEL
button to clear the display.
2.
Press the
PROGRAM
button (the display will
flash)
then press the
2 button. The display will
momentarily show what is stored in the memory
position, then
_ _ _ _ will appear in the display.
3.
Enter the three-digit pager assignment number
and the digit to be displayed. Example: 3527.
4. After the four-digit code has been entered into
the memory position, the PS2000AN will display
_ _ _ _ again to show that the new entry has been
stored.
A group or all pagers can be activated from either contact (see Transmitting a message code to a group of pagers,
page 6).