Command Communications PrivatePage PS2000AN, Руководство оператора, Страница: 10 / 15

7
PS2000AN Operator’s Guide
Contact priority paging sequence
When the PS2000AN is in a normal paging cycle (the
base unit is transmitting a signal to a pager) and either
of the two contacts is triggered, the system will
override the current paging selection and page the
pager(s) assigned to the contact memory.
If Contact 1 is triggered and the system is paging the
assigned pagers, and then Contact 2 is triggered, it will ignore Contact 2 and continue to page the pagers
assigned to Contact 1.
If Contact 2 is in a paging cycle, and Contact 1 is
triggered, it will immediately stop paging the pagers
assigned to Contact 2, and start paging the pager(s)
assigned to Contact 1. In other words, Contact 1 can
override Contact 2, but Contact 2 cannot override
Contact 1.
Receiving a message code
VM200 pager
When a pager is turned
ON
, and receives a page, it
sounds 12 beeps and flashes the received message code
on its display, unless you press the
ON/OFF
switch to
silence the pager before it finishes beeping. Press
ON/OFF to silence the pager when it beeps again, or
the pager beeps once about every 60 seconds to remind
you that there is a new call.
Press
ON/OFF to stop the pager from beeping every
60 seconds.
(If the ??? is set to it will flash only when
receiving a message code.)
VP200 pager
The VP200 pager…Need Info.
VP201 pager
The VP201 pager has two modes of operation as
follows:
1.
In the tone mode the pager beeps when it
receives a message. The pager sounds 12 beeps and
flashes the received message code on its display,
unless you press the
ON/OFF
switch to reset. Press
ON/OFF to silence the pager when it beeps again,
or the pager beeps once about every 60 seconds to
remind you that there is a new message.
Press
ON/OFF to silence the pager from beeping
every 60 seconds.
2. In the vibrating mode the pager vibrates
when it receives a message. The pager vibrates for
3 1/2 seconds and flashes the received message
code on its display.
Press
ON/OFF to reset the pager, or the pager beeps
once about every 60 seconds to remind you that there
is a new message.
Press
ON/OFF to silence the pager from beeping
every 60 seconds.