Command Communications PrivatePage PS2000AN, Руководство оператора, Страница: 8 / 15

5
PS2000AN Operator’s Guide
Transmitting a message code
to groups of pagers
1. Turn the PS2000AN power ON .
2.
Press the
CANCEL
button if the display shows
unwanted pager or message codes.
3. Enter the 3-digit code for the group of pagers you
want to receive the message, then the 1-digit
message code that you want to send.
The
GROUP
button represents 0-9 and can be inserted
into any position of this 3-digit code. This designates
the specific group of pagers to receive the message
code. Example:
Press
10 GROUP (then message code) - sets message
code for pagers numbered 100, 101, 102, 103, 104,
105, 106, 107, 108, 109.
Or, press
1 GROUP 0 (then message code) - sets
message code for pagers numbered 100, 110, 120, 130,
140, 150, 160, 170, 180, 190.
Or, press
GROUP 0 0 (then message code) - sets
message code for pagers numbered 000, 100, 200, 300,
400, 500, 600, 700, 800, 900.
Or, press
0 GROUP GROUP
(then message code) -
sets message code for all pagers numbered 000 through
099.
Or, to page all pagers, press
GROUP GROUP GROUP
(then message code) - sets message code for all pagers
numbered 000 through 999.
If you enter the wrong pager or message code, press
the
CANCEL button, then re-enter the correct codes.
NOTE: You cannot reset either of these codes after
you press the
PAGE button.
4. Press the PAGE button. The TRANSMIT display
lights during transmission, and the pager's display
flashes the message code number 7 times. The four
digits (
GROUP
is represented as " n " on the display)
will remain illuminated until you perform one of the
following actions:
z
Turn the PS2000AN OFF
z
Press the
CANCEL
button
If desired, press
PAGE again to re-send the current
message code to the pager.
5.
Press
CANCEL
, then repeat steps 3 and 4 if you
want to transmit another message code.