Command Communications PrivatePage PS2000AN, Руководство оператора, Страница: 6 / 15

3
PS2000AN Operator’s Guide
Using the PS2000AN
In this section, there are operating notes for using the PS2000AN. Read these notes before attempting to operate the
system.
Overview
Before operating the PS2000AN, be sure that you understand the following information concerning the paging
system's capabilities.
The PS2000AN covers a maximum range of up to 2
miles using the supplied center-loaded antenna. This
distance is based on optimum conditions over a line-
of-sight path. The range might be less, depending on
surrounding conditions.
The PS2000AN sends a number (from 0-9) to a single
pager, a group of pagers, or all system pagers. The
pagers in turn beep or vibrate (VM200 vibrates, VP200
vibrates, VP201 beeps or vibrates) and displays the
numeric message. Each pager has a label where you
can record the message you've assigned for each
number. We recommend that you use a pencil, so the
number can be easily changed at a later date.
Each pager has its own pager code, which allows the
PS2000AN to send a message to selected pagers. You
can record up to 100 pager codes and their
corresponding users on the card located under the
PS2000AN (additional space is provided on the last
page of these instructions).
The card is inside the bottom of the unit and must be
pulled out from the front. You can also write down the
messages represented by each message code. Again,
we recommend that you use a pencil, so the number
can be easily changed at a later date.
Storing the system code
Before you can use the PS2000AN, you must designate a system code. The system code ensures proper signaling
between the PS2000AN and the pagers.
To enter and store a system code, follow these steps:
1. Turn the PS2000AN power ON . (The power switch
is located on the back panel of the PS2000AN.)
2. Press CANCEL to clear display.
3. Press PROGRAM , then 0 . The TRANSMIT
display will show the stored system code
momentarily, then
_ _ _ will appear (after pressing
PROGRAM , the display flashes).
4.
Enter a 3-digit system code. After about 1 second,
the display shows - - - - , indicating the system code
is stored.
(Keypad on the PS2000AN.)
If you enter a wrong code, repeat steps 2 through 4 to reset the system code.
NOTE: If your application requires more than 1,000 pagers, you can use multiple PS2000AN systems. If using
more than one PS2000AN, each system should have a unique system code.