Hearing User Instructions
1.
Plug a single line tone telephone into the PHONE port of the CS8500-t
2.
Pick up the telephone handset and you will hear dial tone
3.
Unplug power, then plug power back in
4.
You will hear three beeps to indicate access to the programming mode
5.
Enter the desired change(s), then press
(you will hear three beeps acknowledging your
changes)
6.
Enter additional changes (if desired)
7.
Press
again to end the programming mode; you will hear dial tone
8.
Hang up the phone
Contact Customer Service at 1-800-288-6794 for additional programming options.
Operation
Single Line Operation
Placing an Outbound Call Using the CS8500-t
You can place an outbound call from the PHONE port, unless another port is in use. If another port is in
use, you will hear a busy signal when you attempt to place a call. If the line is clear when the calling
device goes off-hook, you will hear dial tone and can place the call normally. During an outbound call,
you can also receive a transmission from someone that is ready to transmit.
To transfer this transmission to your FAX port, any time during a conversation, press
from a touch-tone phone.
To transfer this transmission to your TTY/TDD port, any time during a conversation, press
from a touch-tone phone.
Picking up an extension phone not connected to the ANS. MACHINE or PHONE port during a data or fax
transmission may interrupt the call.
CS8500-t Operator’s Guide
12
