Comfort Bilt HP22, Руководство оператора

Страница: 27 / 34

Operator’s Manual
HP22 Pellet Stove
~ 27 ~
SETTING THE EXHAUST VOLTAGE
The exhaust voltage (controlling the combustion
motor)
allows you to adjust the stove for the fuel you are burning or
compensate for inadequate ventilation situations. In less than
optimum venting situations, you can increase the exhaust speed for
additional air circulation through the stove should ventilation be an
issue.
IMPORTANT: Changing the exhaust voltage does NOT
change the feed rate. Therefore, on high heat power levels where
the feed rate is faster, a low voltage level will not push out enough air
and the stove may overheat and pellets may back up into the pot.
Decreasing exhaust voltage will increase the amount of heat coming
into the room. Do not adjust the exhaust voltage too low, as it can
cause pellets to backup in the burn pot.
Increasing the exhaust voltage, and thereby increasing
the
amount of air in the burn pot, will also assist in burning lower-
quality fuels that may otherwise cause unwanted buildup.
NOTE: Be sure to visually watch the burn rate if the
combustion voltage is decreased, as to not cause pot overloading.
Exhaust voltage should ONLY be adjusted to get the optimum
performance out of the fuel you are burning
To set the exhaust voltage:
1. Press and hold the ENTER button. This will take you to the
“
Set Data
”
screen.
2.Using the SCROLL DOWN key, move to option 4:
“Set Exhaust Voltage”. Press ENTER again to move
into the
“
Set Exhaust Voltage” screen. SEE FIGURE
28.
3. Select the stall (heating level) for the voltage you
’
d like to
change by scrolling up or down and pressing ENTER. The
voltage amount will automatically be highlighted.
4. Using the SCROLL UP or SCROLL DOWN keys,
select the appropriate voltage.
NOTE: Voltage can only
be decreased or increased in increments of five (5).
5. Press ENTER to finalize your changes. Repeat steps
2-4 for the other stalls if you so desire.
Set Exhaust Voltage
1.Stall1 Voltage:~80V
2.Stall2 Voltage:~85V
3.Stall3 Voltage:~90V
4.Stall4 Voltage:~100V
5.Stall5 Voltage:~105V
Figure 28
.