Comfort Bilt HP22, Руководство оператора

Страница: 26 / 34

Operator’s Manual
HP22 Pellet Stove
~ 26 ~
SETTING THE TEMPERATURE UNITS
1. Press and hold the ENTER button. This will take you to the
“Set Data” screen.
2. Using the SCROLL DOWN key, move down to
option3:
”
Set Temperature Units
”
. Press ENTER
again to move into the “Set Temperature Units”
screen. SEE FIGURE 25.
3. In the set temperature units menu, press the ENTER
button to highlight the units. Use the SCROLL UP and
SCROLLDOWN buttons to choose either Celsius (C°) or
Fahrenheit (F°).
4. When finished, press ENTER. With nothing highlighted on
the screen, press the EXIT button.
Set Temperature Units
Temperature Units: C°
Figure 25
SETTING THE BLOWER VOLTAGE
The blower voltage (controlling the room fan) can be
turned
up or down for each power level to regulate the amount of
heat circulated into a room during stove operation. Some fuels
radiate heat better than others. You have the ability to speed up or
slow down the room fan to extract the optimum amount of heat
without blowing cold air.
Increasing the blower voltage
causes the convection motor to
run faster, extracting more
heat from the unit.
NOTE: If having issues with the stove overtemping in
any
setting, increase the blower voltage.
Decreasing the blower voltage allows you to slow
the exchange
of heat from the stove so it blows less cold air
To set the blower voltage:
1. Press and hold the ENTER button. This will take you to
the “Set Data” screen.
2. Using the SCROLL DOWN key, move down to
option 4: “Set Blower Voltage”. Press ENTER
again to move into the “Set Blower Voltage” screen.
SEE FIGURE 26.
3.Select the stall (or heating power level) for the voltage
you’d like to change by scrolling up or down and pressing
ENTER. The voltage amount will automatically be
highlighted.
4. Using the SCROLL UP or SCROLL DOWN keys, select the
appropriate voltage.
NOTE: Voltage can be decreased or
increased only in increments of five (5).
5.Press ENTER to finalize your changes. Repeat steps 2-4 for
the other stalls if you so desire.
Set Blower Voltage
1.Stall1 Voltage:~90V
2.Stall2 Voltage:~92V
3.Stall3 Voltage:~94V
4.Stall4 Voltage:~96V
5.Stall5 Voltage:~115V
Figure 26