Comfort Bilt HP22, Руководство оператора

Страница: 23 / 34

Operator’s Manual
HP22 Pellet Stove
~ 23 ~
PRE-OPERATION
Once the stove has been properly installed and plugged into
a grounded surge protector you are ready to begin operation.
MOUNTING YOUR CONTROLLER
Mount the controller and the controller bracket to top and
back of your stove using the hardware that accompanied the
controller SEE FIGURE 18 ON PAGE 21
PRIOR TO STARTING
Turn on the main power switch located on the back of the
stove. SEE FIGURE 20A
NOTE: IF FOR SOME REASON THE STOVE DOES
NOT APPEAR TO BE POWERING ON, THERE IS A
FUSE LOCATED JUST BELOW THE POWER SWITCH
THAT CAN BE CHECKED. SEE FIGURE 20B. NOTE
THAT THERE IS A SPARE FUSE LOCATED IN THE
FUSE HOLDER.
Make sure the hopper is clean and free of foreign matter
including pellet fines and dust. Fill the hopper with wood
pellets, making sure that NO parts of the bag or any foreign
objects enter the hopper as this may cause harm to the auger
feed system. SEE FIGURE 21.
Also take care in making sure there is no pellet material in the
hopper lid seating surfaces.
Close the lid. This stove has a safety switch that will not allow
pellets to feed with the hopper door open.
Make sure the main glass door is closed. The stove has a
safety switch that will not allow the stove to feed fuel unless
there is negative draft pressure inside the stove.
Before actually starting your Stove, you will need to determine
in which mode you would like to run the stove. This stove can
operate in three modes:
1.Manual
: Under this mode, you can personally adjust and
set the heating phase to control the heat level.
2.Thermostat Control (Temperature)
:Under this mode, you
can set the room temperature and the stove will
automatically run to ensure the room is at that temperature.
3.Weekly : Under this mode, the stove will work automatically
during days and times you designate. You can have a
program for each of the seven days of the week and four
periods during the day
You must select your mode before turning on the stove.
Selecting a mode while the stove is burning may cause the
stove to shut down and may force a 30-minute delay in
restarting. You do not need to start operation of the stove to
select your mode.
To choose the mode, select the mode
transfer button . Pressing the mode button once selects
the thermostat setting; selecting it twice will bring you to the
weekly mode
Figure 20a:Main power switch
Figure 20b:Main power switch
Figure 21:Pellet load
WARNING:
NEVER USE FLAMMABLE LIQUIDS SUCH AS
GASOLINE,
GASOLINE TYPE LIGHTER FUEL, CHARCOAL
LIGHTER FUEL OR FIRE STARTING GELS IN OR AROUND
THIS STOVE. KEEP ALL SUCH LIQUIDS WELL AWAY FROM
THE STOVE WHEN IT IS IN USE.
NEVER OPEN SIDE PANELS OR MAIN DOOR
WHEN
STOVE IS IN OPERATION.
NEVER TOUCH DOOR LATCHES WHILE IN
OPERATION,
THEY GET EXTREMELY HOT.
NEVER OPEN GLASS DOOR WHILE STOVE IS
OPERATING
OR WHILE STOVE IS HOT.