Comet U0110G, Руководство пользователя

Страница: 40 / 73

40
IE-LGR-UxxxxM-23
•
If the blue diode does not start flashing at all, then the datalogger‘s
radio section has not been activated at all. It may be caused by
an improper setting: A non-functioning SIM card has been inserted,
the SIM Card has been blocked because a wrong PIN has been
entered, the alarm is not activated at all, no phone number is
assigned to the alarm, and the like). Verify whether the SIM card is
protected by a PIN code. If this is the case, verify if the code has
been entered properly in the device configuration.
- Make sure the SIM card is properly seated in its holder.
Make sure the holder is locked.
- Insert the SIM card into the mobile phone and verify that
the SMS messages function properly. Try the same phone
numbers as those you have stored in the datalogger.
- Check that the datalogger antenna is not damaged and that
it is properly connected.
- Contact your service department (possible failure
diagnostics, wrong interconnection of internal component
parts, …)
•
If the blue LED flashes quickly, but it does not pass over to a slower
frequency, then the modem probably failed to be registered
in the network. Make sure there is sufficient signal strength near the
antenna.
•
If the blue LED flashes quickly and then slowly to go out completely,
the modem has not been registered in the network. The message
has been sent out (but has not arrived), or it has been refused by
the network. Try another phone number of the recipient, verify if you
enter it in the international format (e.g. +420333222111). Verify in
the configuration of the datalogger, that its name contains letters
and numerals only. Do the same with the name of the measured
channel and with the alarm settings in the user-defined descriptions
of the SMS messages. Verify if SMS messages can be sent out from
the respective SIM card: Insert it into the mobile phone and try to
send a text message to the same number. Ascertain whether
the message has been transmitted.
•
Contact the service department in the case that you have not
succeeded in finding the reason of the problem. Diagnostic records
that are saved in the device could deliver further helpful information
for resolving the problem.
Problems arising during sending SMS messages
with
UxxxxG models ______________________________
There are a lot of problem sources in this connection. If sending text
messages does not work at all, you may try out the following steps:
•
Set an alarm on some of the channels so that it might be induced
easily (e.g. temperature alarm by warming the probe by holding it